|
Ground Sleeve
Heights available; 20,25,30,35,40
The most common method of installing a flagpole is by means of a ground sleeve. Typically 10% the height of the flagpole above ground is set below ground level within a ground sleeve. Alliance Fiberglass poles are supplied with a PVC ground sleeve for easy installation.
Please note fiberglass does not conduct electricity and as a result it is not necessary to earth an Alliance Fiberglass flagpole.
Tilt Base (Hinged Base Plate)
Heights available; 30,35,40
Alliance offer a Tilt Base fixing method. Manufactured from hot dip galvanised steel our tilt bases are designed to offer the required support to the flagpole and provide the installer with an easier method to install and service the pole over its lifetime. This method of flagpole fixing can be the most cost effective and efficient long term.
Wall Set
Vertical Wall Bracket
Alliance manufacture vertical wall mounted flagpoles from 15 up to 30 tall as standard. As your preferred pole heights may need to vary due to location, wall condition, amongst other reasons, we would advise direct consultation with our sales team.
Angled Wall bracket
Alliance offer two popular unstayed mountings for our flagpole range at 45 and 60 degrees. Standard pole lengths are from 10 to 14. As your preferred pole heights may need to vary due to location, wall condition, amongst other reasons, we would advise direct consultation with our sales team.
|
